The post Create your own PC moisture sensor via PS2/Gamepad Controller appeared first on The Cheap Vegetable Gardener.
Yet another component for “Project Everbearing” where I need the ability to monitor the moisture level of my soil. There are a couple options on how to do this; the classic method is to take two galvanized nails at a fixed distance apart in the soil. If you run electricity through one of the nails, some of the electricity will pass through the other nail depending on the amount of moisture, in much the same way as a variable resistor works. If the soil is completely dry it will have no conductivity (infinite resistance) since low voltage electricity does not pass through dry soil, as water is added the resistance is decreased and with completely drenched soil almost having complete conductivity.
Unfortunately, I did not have any galvanized nails and with our current snow storm I wasn’t going to venture out to the local Home Depot. I did fortunately have something even better, a handheld soil moisture sensor, which I bought when I started gardening before I learned I can see if I need to water by putting my finger in the soil.
With a little manhandling I got the cover off the back and realized that this tool works with the same principle as the galvanized nails with just two wires with provide variable resistance depending on the water content.
[And I thought my soldering was bad]
Now all that is needed was to solder these wires to a couple open points on my PS2 Controller which I am already using as a cheap temperature sensor The great thing about this implementation is the “resistor” has a broad range from no conductivity to nearly zero. Which is great since it gives a very accurate representation of the soil’s water saturation. For the calibration I was a little lazier this time and only took two points “Dry” and “Really Wet” With these measurements I then calculated the water saturation percentage. So now I can see my plants are at a 43% water saturation level, which I have no idea what exactly that means, but I do know I don’t need to water for a few more days.
One warning though since electrical conductivity can be affected by application of fertilizer (especially synthetic fertilizer which may contain sodium) and temperature so accuracy may be around 70-85% but for higher accuracy there are other expensive ($500) alternatives out there but I can live with this for my application.